7. SEWING
7-10. Using manual mode
In this mode, the needle and the feed bracket can be moved one stitch at a time by turning the upper shaft pulley by hand.
It is useful for checking the positions of the needle and the looper after the looper timing has been adjusted.
(6)
(4) | (5) |
|
(J)
(7) | (1) | (2) |
|
| (3) |
0783Q | 0784Q | 0785Q |
1.Press the MODE button (1) to switch to manual mode.
*“H- 
” will appear in the front panel display (J). ( 
represents the number of stitches remaining.)
2.Press the cloth presser switch (2). The cloth presser will be lowered.
3.Press the start switch (3).
*The knife will operate only when cutting before sewing has been set.
*The feed bracket (4) will move to the sewing start position.
4.Turn the upper shaft pulley (5) toward you.
The feed bracket (4) will move to the next sewing position in accordance with the rotation of the upper shaft. Note: If the upper shaft pulley (5) is turned in the wrong derection, the feed bracket timing may become disrupted.
*To return the feed bracket (4) to the cloth setting position while sewing:
1)Press the EMERGENCY STOP switch (6).
2)Press the RESET button (7). The feed bracket (4) will then return to the cloth setting position.
5.Turn the upper shaft pulley (5) until the last stitch has been sewn. The buzzer will then sound.
Note: Check that the mark on the upper shaft pulley (5) is aligned with the notch in the pulley cover.
6.Press the start switch (3).
*The movement of the feed bracket (4), lower thread trimming and opration of the cloth presser will all be carried out as a single step.
*The knife will operate only when cutting after sewing has been selected.
39
