Xpelair FR22-30 Mounting the Controller, Using your Controller, Looking after the Controller

Mounting the Controller

Remove the Cover and Mounting Frame

1Detach the Fascia from the Mounting Frame by removing the screw covers and two screws (Refer to Fig. 2a&b).

2Detach the Mounting Frame from the Wall Box by removing the two screws (Refer to Fig. 2c).

3Lift the Wall Box away from the Plastic Surround.

4Check that the electrical rating shown inside the controller matches the power supply.

5Disconnect the earth wire from the Wall Box.

6Make cable entry holes in the plastic and metal boxes by removing suitable knockouts (Refer to Fig. 1).

Mounting the Wall Box

Eye protection must be worn during all drilling & chiselling operations.

Check there are no buried Pipes or Cables in the wall or obstructions on the outside e.g. Electricity, Gas, Water.

If surface mounting

1Insert suitable glands into the knockouts.

2Feed both cables through the glands.

3Fix the Wall Box and Plastic Surround to the wall, using the mounting holes provided.

4Reconnect the earth lead to the Wall Box.

If recess mounting

1Make a hole in the wall big enough to take the Wall Box. Discard the Plastic Surround.

2Insert suitable glands into the knockouts.

3Feed both cables through these glands.

4Fix the Wall Box to the wall. Ensure that the

flange of the mounting frame fits flush to the finished surface of the wall (Refer diagram F6).

5Reconnect the earth lead to the Wall Box.

Fig. 1 : Cable Gland Positions Fig. 2a : Removing screw covers

Using your Controller

Operating the Controller

The Controller has the following features: (Refer to diagrams F1-F4).

1	On / Off switch	8	Mounting Frame
2	Intake / Extract switch	9	Wall Box
3 High / Low speed		10 Plastic Surround
4	Indicator light	11 Controllers Terminal Block
5	Ventilation slots	12 Fan’s Terminal Block
6	Screw cover	13 Double Pole Isolator switch
7	Fascia	14 Fuses

Wire the Controller electrical connections

1Mount the Isolation Switch in accordance with the manufacturers instructions.

2Wire the Controller to the Isolation Switch and to the Fan as shown in the appropriate diagram (Refer to Table 1).

3Refit Mounting Frame to Metal Wall Box.

4Refit the Fascia to the Mounting Frame.

5Refit the Screw Covers.

Connect to Power Supply

1Ensure power supply is isolated and fuses are removed.

2Route the Cable from the Isolating Switch to the point of connection to the power supply.

3Make all connections within the Isolating Switch in accordance with the manufacturers instructions.

4Following all local regulations make connection at point of power supply.

5Make a final check to ensure all earth points are connected and all covers have been correctly replaced on the fan, controller and isolating switch.

6Replace all fuses, and switch on the power supply.

For fixed wiring circuits the protective fuse for the appliance must not exceed 5 amps.

For Australia only:

These models are permanently connected to the supply & operation is controlled by a remote switch. They should be directly wired to the supply through an approved 10 amp wall mounted surface switch with at least 3mm clearance between contacts.

Fig. 2b:Removing fascia Fig. 2c: Removing mounting frame

Looking after the Controller

Cleaning

1Before cleaning isolate the Controller completely from the power supply.

2Wipe the Cover carefully with a damp cloth.

3Dry thoroughly.

4Ensure ventilation slots are free from obstuctions at all times.

♦Never immerse the Controller in water

or other liquids.

♦ Never use solvents to clean the

Controller.

♦Apart from cleaning, no other maintenance is required.