Water drainage
The end of the drain hose can be positioned in three ways:
| Hooked over the edge |
| of a sink using the |
| plastic hose guide sup- |
| plied with the machine. |
| In this case, make sure |
| the end cannot come |
| unhooked when the |
| machine is emptying. |
| This could be done by |
P0022 | tying it to the tap with a |
piece of string or attaching it to the wall.
In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground.
Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm.
The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larg- er than the outside diameter of the drain hose.
The drain hose must not be kinked. Run it along the floor; only the part near the drainage point must be raised.
P0023 |
Electrical connection
This machine is designed to operate on a
Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use.
Connect the machine to an earthed socket, in accor- dance with current wiring regulations.
The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution.
5
