INSTALLATION
Transit devices
All transit bolts and packing must be removed before using the appliance.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the
Proceed as follows:
Using a spanner, un- screw and remove the rear
machine does not touch the wall or other kitchen units.
Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any uneven- ness in the floor.
After having levelled the machine, tighten the lock nuts.
P0255 |
packing pieces between the machine and the floor.
2 | 1 |
P0233 |
|
P0254 |
P0509 |
P0802 |
Water inlet
Remove the polystyrene blocks from the underside of the machine and release the two plastic bags by removing the adhesive strip. Unscrew and remove the feet. Carefully remove the
Connect the water inlet hose to a tap with a 3/4" thread after having inserted the small filter “A” sup- plied with the machine.
The inlet hose must not be lengthened. If it is too short
Fit the grid on the bottom of the machine and
and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.
A |
P0003 |
P0021 |
A |
P0789 |
P0256
The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.
Set the machine upright and remove the two remain- ing bolts from the back.
Pull out the three plastic pegs from the holes into which the bolts were fitted.
Plug the open holes with the plugs which you will find in the bag containing the instruction booklet.
Note: You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.
4
