Hearth and Home Technologies ST-550TM-IPI Install Trim Kits and Surrounds, Air Shutter Setting

F. Fixed Glass Assembly

Removing Fixed Glass Assembly

WARNING! Risk of Asphyxiation! Handle fixed glass assembly with care. Inspect the gasket to ensure it is undamaged and inspect the glass for cracks, chips or scratches.

•DO NOT strike, slam or scratch glass.

•DO NOT operate fireplace with glass removed, cracked, broken or scratched.

•Replace as a complete assembly.

Removing Fixed Glass Assembly

•Pull the two glass assembly latches out of the groove on the glass frame (see Figure 14.5).

•Remove glass door from the bracket on the top of the firebox.

Replacing Fixed Glass Assembly

•Replace the glass door on the appliance.

•Pull out and latch the two glass assembly latches into the groove on the glass frame.

•Make sure both sides are replaced properly.

GLASS

ASSEMBLY

LATCHES

(BOTH BOTTOM

AND TOP)

Figure 14.5 Fixed Glass Assembly

G. Install Trim Kits and Surrounds

•Install optional trim kits and/or surrounds using the instructions included with the accessory.

•Use non-combustible materials to cover the gap between the sheet rock and the appliance (if desired).

H. Air Shutter Setting

This appliance has an adjustable air shutter (which con- trols the primary air) factory set for the minimum vertical vent run. If your installation has more than the minimum required vertical vent length, adjustment of the air shutter may be necessary to obtain optimal flame appearance.

This should be adjusted by a qualified installer at the time of installation.

Air Shutter Settings

	NG	LP
Burner	Full Closed	1/8 in.

52 Heat & Glo • ST-550TM-IPI • 2142-900 Rev. B • 11/08