Hearth and Home Technologies ST-550TM-IPI owner manual Junction Box Installation

E. Junction Box Installation

The junction box must be wired from the INSIDE of the appliance:

•Determine which side of the appliance the junction box is located on.

•Pull the electrical wires from outside the appliance through the knockout making sure to use a Romex connector to fasten the electrical wires to the unit.

•Pull enough wire into the valve compartment to easily reach the junction box location.

•Remove the screw attaching the junction box to the junction box bracket and set it aside.

•Route the wire through the knockout in the junction box bracket.

•Wire the junction box and reattach it to the bracket by inserting the tab in the slot and attaching with screw previously removed. Ensure that a Romex connector is used to attach the electrical wires to the junction box.

ROMEX CONNECTORS

NOTICE: DO NOT wire

110 VAC to wall switch.

Figure 12.4 Junction Box Detail

F. Wall Switch Installation for Fan (Option-
	al)
If the box is being wired to a wall mounted switch for use		Minimum 14-3 AWG		Switch
with a fan (See Figure 12.5):
		with Ground
•	The power supply for the appliance must be brought into		Red
			Black	Black
			White	White
	a switch box.	Junction Box	Green	Green
•	The power can then be supplied from the switch box	Red Black White Green
	to the appliance using a minimum of 14-3 with ground			Power
			Switch Box
	wire.			Supply
				Wires
•	At the switch box connect the black (hot) wire and red		Knockout
	(switch leg) wire to the wall switch as shown.
•	At the appliance connect the black (hot), white (neutral)	Red
	and green (ground) wires to the junction box as
	shown.	Figure 12.5 Junction Box Wired to Wall Switch or BC10
• Add a 1/4 in. insulated female connector to the red
	(switch leg) wire, route it through the knockout in the face
	of the junction box, and connect to the top fan switch
	connector (1/4 in. male) as shown.
	Heat & Glo • ST-550TM-IPI • 2142-900 Rev. B • 11/08			45