Brother DH4-B980 Setting the cutting space, Setting the knife position compensation

6.USING THE OPERATION PANEL AND FRONT PANEL G. Setting the number of eyelet stitches

(K)(L)

(N)

1146Q 1147Q

1.The number of eyelet stitches can be set to between 4 and 20 stitches in steps of 1 stitch.

2.Press the “Up” button (L) or the "Down" button (K) to set the desired number of eyelet stitches.

*When the setting value is being changed, the numerals appearing in the display will flash.

3.Press the ENTER button (N) to accept the new eyelet stitch number setting.

*The display will stop flashing.

H. Setting the cutting space

(K)(L)

(N)

1148Q 1149Q

1. The cutting space can be set to between -0.3 and 0.5

mm in steps of 0.1 mm.

Note: You cannot set the cutting space to a value that would make the difference between the knife position compensation and the cutting space less than -0.7 mm.

2.Press the “Up” button (L) or the " Down" button (K) to set the desired cutting space.

*When the setting value is being changed, the numerals appearing in the display will flash.

3.Press the ENTER button (N) to accept the new cutting space setting.

*The display will stop flashing.

I. Setting the knife position compensation

(K)(L)

(N)

1150Q 1151Q

1.The knife position compensation can be set to between -0.7 and +0.7 mm in steps of 0.1 mm.

*If you would like to move the knife closer to the seam, set to a negative value; if you would like to

move it away from the seam, set to a positive value. Note: You cannot set the knife position compensation to a value that would make the difference between the knife position compensation and the cutting space less than

-0.7 mm.

2.Press the "Up" button (L) or the "Down" button (K) to set the desired knife position compensation.

*When the setting value is being changed, the numerals appearing in the display will flash.

3.Press the ENTER button (N) to accept the new knife position compensation setting.

*The display will stop flashing.

24

RH-9800