Matsushita CF-30CTQAZBM Setting the Inverter PCB, TS PCB and LCD Unit, Preparation of Inverter

9.2.3. Setting the Inverter PCB, TS PCB and LCD Unit

1.Set the LCD Unit to the LCD Front Cabinet in order.

2.Attach the 2 drop holders.

3.Connect the Cable to the Connector. (CN200,CN201)

4.Connect the 3 Cables to the 3 Connectors.

5.Fix the Inverter PCB using the 2 Screws. <N5>

Screws <N5>: DRQT26+D4FKL

C

LCD Drop Holder

Connector

(CN201) Connector (CN200)

TS PCB

LCD Drop

A B Holder

LCD Unit	Inverter PCB
	<N5>

C

B <N5>

A

LCD Front Cabinet

to Connector (CN200)

QPreparation of Inverter

* Notes:

1.Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2

2.When handling Inverter-PCB, do not bend or add impact.

Safety Working

		Important Parts
		for Safety
		Inverter-PCB
Do not touch the Transformer part
when attaching to Inverter Case.
	Check the part
	number ’2148M1’

Inverter Shield Case

Prepare Inverter and the Inverter shield Case Outside for Assysite.

Inverter Shield Case Outside

Wrap Inverter Shield Tape around Inverter Shield Case and attach.

Ensure that Inverter Shield Tape does not run over the edge of Inverter Shield Case.

	Inverter is set,	Inverter Shield Case is set
		Attach the Inverter Shield Tape
	attach
Board attachment

<Inverter Shield Tapes Attachment Guide> Protrusion by wrinkles, etc. = 0.2 or less Air Bubble = 1 cm 2 or less / 1 bubble size

Attach it putting the protrusion mark next to the caution label.

Match the board edge and the case edge.

Difference: 0.5mm or less

9-12