Matsushita CF-30CTQAZBM Setting the LCD Rear Cabinet, Hinge L and R, Assembly of LCD Unit

QAssembly of LCD Unit

* Notes:

1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2

Confirm that the LCD

Cushion is not wrapped.

Attach the Inverter MIL Shierd

Match to the LCD edge and attach it.

Clearance : 2 mm or less

0 0.5mm

Attach the TS Controller

LCD Drop Holder Insertion

LCD Front Ass’y

LCD Drop Holder Insertion

Flex Stiffening Plate Edge
	Release Paper B
TS Flex Insertion
	Release Paper A
Attach the Tape	Release Paper C

* Notes:

1.Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm

1.Insert the TS Flex into the TS Controller, and attach the tape.

2.Remove the Release Paper A and attach the TS Controller. (Do not come off the sheet and apply the pressure on the LCD.)

3.Remove the Release Paper B and attach it on the TS Controller.

4.Remove the Release Paper C and attach it on the LCD.

9.2.4. Setting the LCD Rear Cabinet, Hinge L and R

1.Fix the Hinge L and R using the 2 Screws. <K9-1-4>

2.Set the LCD Latch.

3.Fix the LCD Rear Cabinet using the 4 Screws. <N7> No1 to No4

4.Fix the left and right LCD Cover Side Cover using the 4 Screws <N7> and 2 Screws. <N13>

5.Fix the 2 Wireless Antenna Corner Cover using the 4 Screws. <N7>

Note:

Tighten the Screws in the numbered order (No1 to No4).

Screws <N2>: DRHM5054XA

Screws <N7>: DRSB26+10HKL

Screws <N13>: DRSB4+10FKL

Screws <K9-1-4>: DRYN4+J10KLT

left LCD Cover <N7> <N13>
Side Cover<N7>	No.1
<N7>	<N7>	LCD Rear Cabinet
		No.4
<N7>
		<N7>
No.3
<N7> No.2		<N13>
<N7>		<N7>
Wireless Antenna		<N7>
Corner Cover		<N7>
LCD Latch	<N7>
<K9-1-4>		right LCD Cover
Hinge L		Side Cover

Wireless Antenna

Corner Cover

<K9-1-4>

Hinge R

LCD Front Cabinet

9-13