6. USING THE OPERATION PANEL AND FRONT PANEL
P1. Setting X correction
(K)(L)
(N)
1152Q | 1153Q |
1.The setting range is from 1 to 6 in steps of 1.
*Set to a larger value if you would like to move the eyelet seam to the right (when seen from the finished side, or the reverse side when sewing).
2.Press the “up” button (L) or the “down” button (K) to set the X correction value.
*When the setting value is changed, the value displayed will start to flash.
3.Press the ENTER button (N) to accept the X correction setting.
*The display will stop flashing and will start illuminating steadily.
P2. Setting Y correction
(K)
1154Q
P3. Setting θ 1 correction
(K)
1156Q
(L)
(N)
1155Q
(L)
(N)
1157Q
1.The setting range is from 1 to 6 in steps of 1.
*Set to a larger value if you would like to move the
2.Press the “up” button (L) or the “down” button (K) to set the Y correction value.
*When the setting value is changed, the value displayed will start to flash.
3.Press the ENTER button (N) to accept the Y correction setting.
*The display will stop flashing and will start illuminating steadily.
1.The setting range is from
*Set to a larger value if you would like to rotate the seam which is not part of the eyelet clockwise (when seen from the finished side, or the reverse side when sewing).
2.Press the “up” button (L) or the “down” button (K) to set the θ 1 correction value.
*When the setting value is changed, the value displayed will start to flash.
3.Press the ENTER button (N) to accept the θ 1 correction setting.
*The display will stop flashing and will start illuminating steadily.
25