NOTES ON REMOTE CONTROL USE:
Theremote control operates on a 3 volt lithium battery (type
CR-2025). Install the battery into the compartment at the
bottom of the remote control, making sure to observe
correctpolarity (match “+” side of battery to “+” indication on
compartment).
If remote control fails to operate, always check battery
conditionand replace if necessary before servicing the unit.
Disposeof batteries properly. Donotheat, disassemble, or
throw batteries into a fire.
Keepthe remote control away from areas where it may be
exposed to heat, moisture or sunlight.
9INFRARED SENDER
Thewireless signal from the remote control is sent from this lens.
Foroptimal range and performance of the remote control, always
aim the Sender at the Remote Sensor bm on the wired com-
mander. Do not let your finger interfere with the signal and make
sure the lens does not become blocked by dirt, dust, etc. If
necessary, clean the lens with a soft dry cloth or cotton swab.
7TRACK/DISC SHUFFLE (SHF)
See wired Commander 8
8TRACK/DISC (SCN)
See wired Commander 9
8