Audiovox RB3600 manual Installation and Wiring Instructions, Amplifier Module

INSTALLATION AND WIRING INSTRUCTIONS

AMPLIFIER MODULE

Mount the amplifier module in a location that is conveniently accessible to the rear speaker wiring harness. It is these wires that the RB-3600 interrupts. It is not necessary to mount the amplifier module close to the television. Connect one end of the 10-pin cable assembly to the amplifier module (see figure #1 ).

Cut the wires to the rear radio speakers Connect the rear speaker(s) as follows:

Left	rear		speaker(s)		+	:white wire on 4-pin connector
Left	rear		speaker(s)		+	:purple wire on 4 -pin connector
Right		rear		speaker(s)		:blue wire on 4-pin connector
Right		rear		speaker(s)		:green wire on 4-pin connector

Connect the dash radio rear amplifier outputs as follows:

Left rear amplifier Left rear amplifier Right rear amplifier Right rear amplifier

+:grey/white wire on S-pin connector :grey wire on S-pin connector

+:brown/white wire on S-pin connector :brown wire on S-pin connector

Connect 12 'Jolt power to the RB-'3600 as follows:

+12 volt power	:red wire on S-pin connector
Ground
	:black wire )n S-pin connector

Connect the Audiovox television external speaker output to the RB-3600 as follows:

External	speaker	output	+	:pink blue wire on S-pin connector
External	speaker	output		:black/white blue wire on S-pin connector

Unplug the audio output of the VCP. Connect the isolation transformer as follows:

Isolation transformer male RCA : to VCP audio output

Isolation transformer female RCA : to RCA cable that was plugged into the VCP