Universal Remote Control Owner’s Manual
RCR412BR / RCR412SR / RCR412SIR
Manual del Propietario (parte posterior)
SAVE THIS MANUAL AND THE CODE LISTS!
Remote controls can sometimes lose their programming when you change the batteries. Make sure you keep the manual and code lists in a safe place so that you can reprogram the remote if you need to.
Tip: This remote is already programmed to operate most
Step 1: Install your batteries
Your universal remote requires two AA alkaline batteries (batteries may or may not be included, depending on model).
To install the batteries:
1.Remove the battery compartment cover.
2. Insert the batteries, matching the batteries to the (+) and
3.Push the battery cover back into place.
Battery Precautions:
•Do not mix old and new batteries.
•Do not mix alkaline, standard
•Always remove old, weak or
Battery Saver
Your universal remote control saves battery power by automatically turning off if any key is pressed for more than 60 seconds. This saves your battery life should your remote get stuck in a place where the keys remain depressed, such as between sofa cushions.
Step 2: Program your remote
To use this universal remote with your home entertainment system, first you need to program it to control your devices. There are four ways you can program the universal remote to operate your devices:
•The Auto Code Search goes automatically through all the codes for the device you’re trying to control. It’s the easiest method, but it can sometimes take longer than some of the other programming methods.
•The Brand Code Search searches through the codes for select brands of devices. It’s not as easy as the auto code search, but it can be faster.
•The Direct Code Entry lets you enter a code from the accompanying code list for your brand of device. It’s not as easy as the other methods, but it’s potentially the fastest method.
•The Manual Code Search lets you manually go through all the codes for the device you’re trying to control.
Auto Code Search
The Auto Code Search goes automatically through all the codes for the device you’re trying to control. When you find the one that operates your device, you can stop the search and store that code.
TIPS: Each device key is associated with a type of device— the TV is preset to search for TVs, SAT•CBL•DTC for satellite receivers, cable boxes or digital TV converters, DVD for DVD players, and VCR•AUX for VCRs or DVRs. To program a device key for a different type of device, see the Changing a Key’s Device Type section.
To exit without saving a new code at any point in the Auto Code Search, press the GO BACK key.
1. Manually turn on the device you want to control.
2.Press and hold the device key you want to program. While you’re holding down the device key, use your other hand to press and hold the remote’s ON•OFF key at the same time.
3.Wait until the ON•OFF key comes on and stays on. Then release both keys.
4.Point the remote directly at the
front panel of the device you want to control. Press PLAY on the remote and wait 5 seconds. The remote is testing a batch of 10 codes on your device.
Did your device turn off?
YES: Go to step 5.
NO: Press PLAY again. The remote tests the next batch of 10 codes.
Keep pressing PLAY every 5 seconds until your device turns off.
