BASE |
|
|
|
|
| SCREW HOLES |
ASSEMBLY |
|
|
|
|
| (4) FOR DIRECT |
MOUNTING |
|
|
|
|
| HARD MOUNTING |
PLATE |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
MOUNTING
BASE
ASSEMBLY
MOUNTING | PLASTIC LINER |
PLATE | AND ADHESIVE |
| BACKING |
e.If the outside air temperature is cold, it may be beneficial to warm the adhesive backing on the base using a portable hair dryer, or by holding the backing surface in front of a vehicle heater vent.
f.Remove the plastic liner from the adhesive backing on the base, and fix the base in position on the surface; make sure the mounting pad is accurately positioned on the first try, since repositioning may be difficult, if not impossible.
g.If the mount is to be screwed in place, do not remove the plastic liner from the adhesive backing. Use appropriate sheet metal or machine screws for this purpose.
128-7194
10 of 20
