SIR4-Truck Satellite Radio Antenna
Mirror Mount Installation
NOTE: The mounts supplied may not fit on all model year and make truck mirrors. If your rig does not have the chrome pipe type mirror bars you will need to use the Air Dam Shield mounting method or flat surface mounting method.
1.Insert the Antenna Assembly into the Mirror Mount Clamp hole. See Figure 2 on page 5.
2.On the bottom side of the Mirror Mount Clamp A place the 3/4” Ext. Tooth Lock Washer on the Antenna Assembly Shaft.
3.Now place the
4.Using a torque wrench tighten to
5.Select the highest location on the truck mirror to mount the satellite radio antenna without obstruction.
6.Take the four M6XP1.0 Hex Screws and insert them through the four holes in Mirror Clamp A.
7.Take Mirror Mount Clamp B and insert them onto the four M6XP1.0 Hex Screws and Mirror Mount Clamp A.
8.Now place the four M6 Lock Washers onto the M6XP1.0 Hex Screws.
9.Now place the four M6 Washers onto the M6XP1.0 Hex Screws.
10.Now use the M6XP1.0 Hex Nuts and hand tighten all four onto the M6XP1.0 Hex Screws.
11.Using the torque wrench torque the M6XP1.0 Hex Nuts to 15
Figure 4. Mirror Mount Cable Routing | Figure 5. Mirror Mount Cable Routing |
|
|
|
|
|
|
|
7
