Audiovox SIR4 owner manual Cable Connector/Rubber Boot Connection

Mirror Mount Installation Continued

12.Take the cable connector (180 degree connector) not the Right-Angle SMB Connector and hand tighten over the connector on the bottom side of the Antenna Assembly. See Figure 6.

13.Using the 5/16” open-end wrench, tighten the cable connector on the Antenna Assembly connector.

14.Place the rubber boot over the end of the Antenna Assembly shaft after the cable connector has been tighten. See Figure 6.

15.The next step is routing the cable from the Antenna Assembly to the satellite radio receiver inside the truck cab. Since every truck cab is slightly different this is only a guide line to follow and your cable routing maybe different.

16.Route the cable through the vent window of the truck cab. Again DO NOT BEND the cable at 90 degree angles as this will break the coax center conductor causing the satellite receiver not to receive the satellite radio broadcast. See Figure 4.

17.If you have an access hole and do not want the cable routing through the window vent route the cable through this hole. See Figure 5.

18.Connector the Right-Angle SMB connector to the satellite radio receiver.

Figure 6. Cable Connector/Rubber Boot Connection

8