Audiovox SP-11CDS installation manual Procedure For Horizontal Installation W/O Studs

INSTALLATION

The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (lef t and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective and vibration may cause the disc to skip.

CAUTION

After setting the built-in anti-vibration springs, place masking tape over the holes. The tape will keep out dust, which could cause the unit to malfunction.

HORIZONTAL INSTALLATION Set the 2 anti-vibration springs to position "0".

VERTICAL INSTALLAITON Set the 2 anti-vibration springs to position "90".

45° ANGLE INSTALLATION

Set the 2 anti-vibration springs to position "45°".

ANTI-VIBRATION SPRINGS POSITION

PROCEDURE FOR HORIZONTAL INSTALLATION W/O STUDS

1

Attach a bracket to each side of the unit, using the machine screws with integral flat and lock washers (M4 x 10).

In the horizontal position, use bracket mounting holes 1 and 1' as shown at the right.

Set anti-vibration springs to position "0" as shown above.

NOTE: Use masking tape to cover un- used mounting holes on sides of unit.

1

2

3

1

2

3

MACHINE SCREW WITH FLAT AND LOCK WASHERS (M4 x 10)

2

Determine unit mounting location, and drill four mounting holes.

Never mount the unit near the fuel tank.

DRILL HOLES 4MM IN DIAMETER

3

Secure the unit in place, using four self-tapping screws (M5 x 12).

Use RTV (silicone sealer) on screw threads and around the holes to prevent moisture intrusion.

BRACKET (Left Side)

SELF-TAPPING SCREWS (M5 x 12)

BRACKET (Right Side)

4