PROCEDURE FOR VERTICAL INSTALLATION W/O STUDS
Note
If the
1
Set the 2
2
Attach bracket to each side of the unit, using machine screws with integral flat and lock washers. (M4 x 10).
In the vertical position, use holes 2 and 2' as shown at left.
NOTE: Use masking tape to cover unused mounting holes on sides of unit.
3
Determine the mounting location, and drill four mounting holes.
Never mount the unit near the fuel tank.
BRACKET (Left Side)
MACHINE SCREWS w/WASHERS (M4x10)
BRACKET
(Right Side)
4 Mount the unit in place, using four
Use RTV (silicone sealer) on screw threads and around the holes to prevent moisture intrusion.
BRACKETSCREWS (M5 x 12) (Left Side)
DRILL HOLES 4MM IN DIAMETER
BRACKET (Right Side)
5