Audiovox SRSIR-001FM, SRSIR-001FMR manual Satellite Radio Receiver Unit RRU, Scan Functions

When pressed and held, this button allows you to switch between pre-set channel groups 1 and 2. This button is also used to invoke the Category Mode, which can also be achieved by Momentarily Pressing and Releas- ing the (SFT) button then Pressing and Holding the (SFT) button again

for 2 seconds, “ENTER CATEGORY TUNE” or “ENTER CHANNEL TUNE” will be displayed .

7.Power On/Off ( ) Button: Press this button to apply power to the Satellite Radio Receiver system. The associated radio must be turned on and off separately using its power switch.

This button is also used to back light the number keys when the system is on. To do so, momentarily pressed and release the Power On/Off Button. The back lighting will last for 10 seconds.

8.Mute Function Button: Momentarily press the shift (SFT) button; then press and hold the Down directional (W) button to enable the audio mute function. When enabled, the audio program is muted and the Mute

icon ( ) appears in the lower right corner of the SCU display. Press any button to exit the mute function.

9.Scan Functions:

Scanning All Channels – [enter code (SFT)+0960+(SFT)] Momen- tarily press the Shift (SFT) button; then press and hold the Up directional button (X) for 2 seconds to enable the Channel Scan function. When enabled, each channel is scanned in the either direction for 10 seconds before moving on to the next active channel. This permits channel preview or introductory sampling of channel programming. The channel (CH) icon on the SCU screen will appear in reverse image (white-on-black) format. Press any button to exit the Scan function.

Scanning Preset Channels - [enter code (SFT)+0961+(SFT)] This function works in the same way as the Scanning All Channels mode, except this mode will only scan the preset channels. You can configure a total of 40 preset channels, 20 in Channel Mode (two groups of 10 chan- nels, upper and lower) and 20 in Category Mode (two groups of 10 channels, upper and lower). Preset channel being previewed are displayed in the lower right corner. A black number on white background indicates that it is part of the upper group of channels and a White number on a Black background indicates that it is part of the lower group. When scanning these channels an indicator will appear in the right corner of the screen.

·(SR1) = Lower Preset Channel Group (first 10 channels)

·(SR2) = Upper Preset Channel Group (next 10 channels) To switch between the two groups of preset channels press and hold the Shift (SFT) button for 2 seconds until a tone is heard indicating the switch was made.

SATELLITE RADIO RECEIVER UNIT (RRU)

The RRU is a central data-receiving unit, which is required to process the satellite signals received by the externally mounted antenna (purchased separately). The RRU contains the processing logic needed to recognize, decode the incoming SIRIUS® program information and then distribute a recognizable RF signal to the FM Switching Box .

NOTE: The SIRIUS® signal can be received and processed virtually anywhere as long as there are no obvious Satellite Signal Obstructions such as parking garages, tunnels.

The RRU is typically installed under the seat or in the trunk/rear of the vehicle.

4

128-6374A

4 of 12