5
INSTALLATION
SUB-WOOFER ENCLOSURE
The SU-101 sub-woofer enclosure is designed for horizontal (flat) mounting. It must never be mounted upside-down
or on either of it's sides. The most convenient area for enclosure installation is within the trunk of cars, such as sedans,
or on the rear cargo area of vans and SUVs. It is also possible to mount the unit behind the front seat area of utility and
pick-up trucks if space allows.
The following procedure outlines the basic installation criteria for the enclosure.
1. On a flat surface, place the enclosure upside down and determine the position of each of the four mounting
brackets; each should be positioned in from each corner approximately 2 inches.
2. Attach each bracket using four of the 5mm x 25 self-tapping screws supplied.
NOTE: Make sure to orient each bracket so the tab contacts the side of the unit. This will prevent the bracket from
shifting during vehicle movement, sudden stops, etc.
3. Secure the enclosure to the surface (trunk or deck ) of the vehicle in the desired position. If desired, a mounting platform
of 3/4" plywood or other material could be used to compensate for uneven surfaces within the vehicle; the enclosure
could then be mounted to this surface.
4. Center the enclosure either on the vehicle surface or on the mounting platform and secure the unit using the remaining
four 5mm x 25 self-tappingscrews through the bracket holes.
5. Proceed to the wiring diagram on page 8 of this manual.
ENCLO-
SURE
BOTTOM
2 inches 5mm x 25 SELF-
TAPPING SCREW
ENCLOSURE
MOUNTING
BRACKET
MOUNTING PLAT-
FORM (3/4" PLYWOOD
OR OTHER MATERIAL)
ATTACHED TO
VEHICLE
5mm x 25 SELF-TAPPING
SCREW