Audiovox VOD1221 S, VOD1221 P manual

VOD1221

*OPTIONAL RELAY BOX

SIRSWB

*ANTENNA FOR WIRELESS FM MOD	DIN 2
	1
	DIN
** See Antenna Note Below
	UNIT (BACK VIEW)
***PODTVT	PODTVT

Power Harness

Accessory

Harness - Optional

(P/N:8010730)

Red RCA (Audio Right)

White RCA (Audio Left)

Yellow RCA (Video)

To TV Antenna In

TV ANTENNA

Line Out-L (White)

Item #3

(Red)	V (Yellow)
Line Out-R	Line Out-

Dome Light Power Source

Power Connector	"Y" Adapter
4 Pin	for use with
Clean the IR Receiver Window on the front of the VCP.	Non-Stereo
Remove Adhesive Backing and Apply IR LED to IR	Installations
	Item# 5

Figure A

Item #3

Power Harness

CHOKE

	To Secondary AV Monitor
TO		RCA-Female	INPUT	12 VDC Power and Ground
OPTIONAL			VIDEO
ADDITIONAL	LINE
MONITOR				Auxillary
	OUT	Patch Cord
	VIDEO			video display
		RCA Male to Male

(Yellow)

1)Make the connections to the vehicle for the 12 pin wiring harness.

2)Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.

3)Pull the wire tie loop tight and cut off the excess.

4)Connect the 12 pin harness to the mating connector on the Video Monitor.

5)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line and a good ground.

6)Verify all functions of the System before final mounting of the finished assembly.

7)Mount and connect the Television antenna. (Optional)

Note: A VCP or other A/V Component can be connected to the video monitor system using a second source

component harness (purchased separately, part number: 8010730). This harness would plug into the Mini-Din connector on the main PCB as in steps 2 and 3 above.

A/V Source Definitions:

1.DVD – Built in DVD

2.AUX-IN – VCP, Game or future DVD etc...

3.AV1 – VCP or VCP with TV Tuner (Mini-Din on main PCB)

4.AV2 or TV – When PODTVT is connecting the unit, TV will replace AV2.

*NOTE: If the original relay box P/N SIRSWB is installed, it recommended that the antenna for the wireless FM Modulator be unplugged. See Figure A for antenna location.

**NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM Modulator to exceed FCC limits for wireless transmission. When installing the unit position the antenna for best reception.

***NOTE: When PODTVT is used the AV2 input position does not work.

6