Audiovox VOD701 manual VOD702

VOD702

			Red RCA (Audio Right)	Hard Wired FM Modulator Output
			White RCA (Audio Left)	12 VDC Power and Ground			* REFER TO PAGE 8 FOR FURTHER DETAILS
			Yellow RCA (Video)
					Satalite
				FM	Radio	Am/Fm	TO
			14Pin FMM Cable			Antenna	FACTORY
				Modulator			RADIO
			Item #8			Dash Radio
	Power Connector	"Y" Adapter	Accessory
IR LED:	4 Pin	for use with
			Harness - Optional
Clean the IR Receiver Window on the front of the VCP.		Non-Stereo
Remove Adhesive Backing and Apply IR LED to IR		Installations	(P/N:8010730)

Window on the Face of the VCP. Item# 5

TV

Antenna

1

Power Harness

Item #3

Dome Light

Power Source

Line Out-V (Yellow)

Line Out-R (Red)

Line Out-L (White)

Optional Remote Headphone Stations

Green	Stereo
(Right+)	Headphone Jack
Black	Stereo
(Ground)	Headphone Jack

Gray (Left+)

To Secondary AV Monitor

	RCA-Female	INPUT	12 VDC Power and Ground
		VIDEO
LINE			Auxillary
OUT	Patch Cord
VIDEO			video display
	RCA Male to Male
(Yellow)

Power Harness

Item #3

CHOKE

TO

OPTIONAL ADDITIONAL MONITOR

Battery12V

Second IR

Input

Figure B

1)Make the connections to the vehicle for the 12 pin wiring harness and battery wire.

2)Open the cover to gain access to Mini-Din Connector on main PCB.

3)Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.

4)Pull the wire tie loop tight and cut off the excess.

5)Connect the 12 pin harness to the mating connector on the Video Monitor.

6)Connect the wired headphone to the remote headphone jacks to the video monitor if those options are being included.

7)Connect the 14 Pin wire to the FM modulator.

8)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line.

9)Mount and connect the Television antenna.

10)Verify all functions of the System before final mounting of the finished assembly.

Note: A VCP or other A/V Component can be connected to the video monitor system using a second

source component harness (purchased separately, part number: 8010730). This second harness would plug into the second Mini-Din connector on the main PCB as in steps 2 and 3 above.

A/V Source Definitions:

1= TV Tuner

2= VCP (Mini-Din on main PCB)

3= AUX-IN (game or future DVD, etc...) 4= Built-in DVD

-7-