Audiovox VOH-642 manual VOH-641, Factory

VOH-641		as shown.
		Note: cables
		exiting the pod
		should be routed
		Wireless FM Modulator
	Power Harness	Antenna
Red: +12 VDC
	Item # 3a4	Mini-Din Connectors
(Accessory Cir.)
		choke
Black: Ground

Optional Hard Wired FM Modulator Output

	12 VDC Power and Ground		Left	RCA-Female
	Am/Fm	FM	Input
TO	Antenna			LEFT
		Modulator		WHITE
FACTORY				RIGHT
				Patch Cord
RADIO	Dash Radio	1070610	Right	RED
		*Refer to Instructions with the RF
			Input
		Modulator Kit for further details.		RCA-Female

		To Secondary AV Monitor
TO	12 VDC Power and Ground	INPUT	RCA-Female
OPTIONAL		VIDEO
				LINE
ADDITIONAL	Auxillary
			RCA Male to Male	OUT
MOINTOR	video display			VIDEO
			Patch Cord

2 1

Accessory	Accessory
Harness	Harness
Item# 2	Item# 12
	Red RCA (Audio Right)
	White RCA (Audio Left)
	Yellow RCA (Video)

Optional Remote Headphone Stations

Stereo	Green
Headphone Jack	(Right+)
Stereo	Black
Headphone Jack	(Ground)
	Gray
	(Left+)

IR LED: Clean the IR Receiver Window on the front of the VCP. Remove Adhesive Backing and Apply IR LED to IR Window on the Face of the VCP.

"Y" Adapter

for use with

Non-Stereo

Installations

Item# 53b

1)Make the connections to the vehicle for the 12 pin wiring harness.

2)Remove screws on PCB Cover. Open the cover to gain access to Mini-Din Connector on main PCB.

3)Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB

4)Pull the wire tie loop tight and cut off the excess.

5)Connect the 12 pin harness to the mating connector on the Video Monitor.

6)Connect the wired RF Modulator and / or the remote headphone jacks to the video monitor if those options are being included.

7)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line.

8)Reinstall PCB cover using the 2 screws.

9)Verify all functions of the System before final mounting of the finished assembly.

Note: A second VCP or other A/V Component can be connected to the video monitor system using a

second source component harness (purchased separately, part number: 8010730). This second har- ness would plug into the second Mini-Din connector on the main PCB as in steps 2 and 3 above.

A/V Source Definitions:

1= VCP (Right Mini Din on main PCB)

2= 2nd VCP (or game or DVD, etc.…. left Mini Din)

3= Aux Input (RCA jacks on the face of the monitor).

-6-