4. Press the “Open” button on the side of the umbrella light
to open the umbrella light.
5. Close the umbrella light beneath the collar clamp.
6. Move the umbrella light up to the collar clamp. Snap in
the umbrella light by aligning the two tabs of the collar
clamp with the notches of light, then push up. Unlatch the
collar and slide light to desired height and close latch.

2) RELEASE THE LIGHT

- press the “Open” button on the side of the umbrella light to open the umbrella light
- remove the umbrella light from the pole
- pull the plastic clip to open and release the collar clamp

3) INITIAL CHARGE

- plug in the adaptor to charge the battery 12 hours before first use
- repeat this procedure every three (3) months to fully recharge the battery
- the umbrella light can be charged if the light is ON or OFF

4) DAILY CHARGE

- plug in the adaptor to charge the battery
- red light illuminates during charging and the light turns to green when the battery is
fully charged

5) To turn ON:

- press ON/OFF button on the side of the umbrella light

6) To turn OFF:

- press ON/OFF button on the side of the umbrella light
- for extended periods of non-use (storage),
turn the power switch to OFF position
- never store unit with power switch in the
ON position. This will damage the battery
and it will not recharge
** Only use the supplied AC Adaptor to charge the light. Charging the light with a substitute AC
Adaptor may cause damage to the light
32
ON/OFF
Button
Adaptor plug
PRESS
Open Button
Tab
Notch