864 ST Fireback Installation
SKU # 96100184 – 96100186 – 96100189 - 96100190
4Carefully place the floor firebacks into position. You must tip them under and around the corners of the burner.
5Carefully replace the front and rear grates (they rest on top of the floor firebacks).
WARNING:
When replacing the grate do not drag the grate across the firebacks (they damage easily). You may need to lift the burner slightly while installing the grate.
NOTE: These tabs are bent out when using the accent light. Make sure to carefully bend them flush if the accent light was previously installed (then reposition them after firebacks are installed).
6Install the side firebacks following the directions below.
7Restore the fireplace to the correct configuration.
a
Remove the clips on both sides (loosen the screws
a couple turns and slide clips up and out).
5/16" Nutdriver
b Place the side firebacks into position.
c Secure the clips to anchor the side firebacks.
The ceramic firebacks are fragile. Ensure proper alignment of individual pieces in each step. To achieve the ideal appearance, you may need to make slight adjustments.
Page 2 of 2 | 9/15/08 | Travis Industries, Inc. |
