20 Operation
Travis Industries 4050225 100-01154
Loading PelletsLift the hopper lid to its vertical position. Pour pellets into the hopper until full. NOTE: The hopperholds approximately 115 pounds of pellets.
Make sure pellets
are not left on this
heat shield.

P

et
e

l

s
l
To Close the Hopper Lid:
lift the lid, pull this tab forward,
then lower the lid down.
To Open the Hopper Lid:
lift the hopper lid from this handle.
These notches allow
you to open the hopper
lid to the level you wish.
Warning:
The front edge of the
hopper lid becomes very
hot, do not touch the area
below the handle.
The Two Modes of Operation:ManualManual mode requires the user to turnthe heater on and off manually.Auto (requires a thermostat)Auto mode allows you to use athermostat to control roomtemperature. The stove automaticallyturns on when the temperature dropsbelow the thermostat setting. Once thestove reaches operating temperature,the stove then runs at the heat outputsetting selected.Switching Modes While inOperationWhenever the stove is switched fromone mode to another while inoperation, the stove will enter the "start-up" sequence for a minimum of 20minutes.
HIGH
DISCONNECT POWER BEFORE SERVICE
REMOTE
AUTO
MANUAL
H
E
A
T
O
U
T
P
U
T
MED
LOW
AUGER
FAULT
AUTO
OFF
MANUAL
H
E
A
T
F
A
N
UP
DOWN
UP
DOWN
MANUAL
MANUAL
START
AUGER
TRAVIS INDUSTRIES
HOUSE OF FIRE
TM
Use the mode
switch to
determine the
mode.
These indicator lights
are used to determine
which mode you are in.
NOTE: if using a
modulating remote, this
light will come on to
indicate the remote is
controlling the heater.