Optional Equipment 41
Travis Industries 4050225 100-01154
Remote Thermostat
Follow the instructions included with the remote thermostat for installation.
Using the Remote Thermostat
The remote thermostat has a 1 to 2 minute lag time between the time the thermostat is turned up and
the heater turns on. Included with the remote thermostat is a set of instructions that details the
operating characteristics of this optional component.
Pellet Log (part # 98900126)
! Make sure the heater has fully cooled before installation.
1 Assemble the log shelf following the directions below.
Right Log Shelf Leg
Left Log Shelf Leg
Log Shelf Cross Brace
3/8" Nutdriver
Nuts
2 Remove the firepot from the pellet stove. Center the log shelf
assembly (with extender attached) over the burnpot holder.
Replace the burnpot. Place the log on the log shelf extender.
When in place, the log should appear as shown in the
photograph to the right.
Center the log on the log shelf and
push it back so it rests against
these two tabs. Place the log shelf assembly so the
back edge contacts the cast firebrick
in the rear of the firebox. Note how
the taper on the assembly matches
the taper on the cast firebrick.
a
b
NOTE:
On inserts, the ash box must be
installed before placing the log shelf
assembly.