Operation 31
Travis Industries 100-01169_001 4050119
Adjusting the Blower Speed (optional)

The blower helps transfer heat from the heater into the room. It will not turn on until the heater is up to

temperature (approximately 10 minutes after starting). See the illustration below for instructions on

adjusting the blower speed.

ON
OFF
ON
OFF
ON
OFF

OFF

Turn the dial all
the way counter-
clockwise until it
clicks off.

HIGH

The high position is
all the way counter-
clockwise, without
clicking off.

LOW

Turn the dial
all the way
clockwise.
Normal Operating Sounds
Gas Control Valve
As the gas control valve is turned
on and off you will hear a dull
clicking sound. This is the valve
opening up and shutting down.
Blower Snap Disk
This part can produce a clicking sound as
it turns the blower on and off.
The appliance may creak with change of
temperature -- THIS IS NORMAL.
Pilot Flame
The pilot flame,
which remains on,
makes a very slight
"whisper" sound.
Blower
This heater uses a blower to push heated
air into the room. You will hear the sound
of air movement that increases as the
speed is increased.
Extinction Pops
It is not unusual, especially on Propane
(LP) appliances, to experience a "pop"
when the burner is shut off.
Normal Operating Odors

This appliance has several areas that reach high temperatures. Dust or other particles on these areas may

burn and create a burnt-paper smell. This is normal during startup. You may notice the smell is more acute

if the appliance was left idle for a long period.