Avanti DW184B, DW183W, DW182ESS ¾Push Dishwasher Into Final Position, ¾Drain Line Installation

Models: DW182ESS DW183W DW184B

1 38
Download 38 pages 47.84 Kb
Page 33
Image 33
¾Push Dishwasher Into Final Position

WARNING

The plumbing installation shown below must be performed by a qualified and licensed plumber, following all of the electrical codes and ordinances required by the State.

¾Push Dishwasher Into Final Position

The dishwasher must be secured to the countertop or the cabinet sides.

Check to be sure that wires are secured under the dishwasher and

not pinched or in contact with door springs or other dishwasher components.

TIP: Check tub insulation blanket. It should be positioned so it is not bunched up or interfering with door springs. Check by opening and closing door.

Push dishwasher into the cabinet. The front corners of dishwasher door should be flush with cabinet doors. Be careful not to dent front panel with knees or damage countertop or cabinets with dishwasher parts.

Fasten the dishwasher with the 2 Philips screws provided.

¾Connect Water Supply Connect water supply line to 90º elbow.

Slide compression nut, then ferrule over end of water line.

Insert water line into 90º elbow.

Slide ferrule against elbow and secure with compression nut. IMPORTANT: Check to be sure that door spring does not rub or contact the fill hose or water supply line. Test by opening and closing the door. Re-route the lines if necessary.

¾Drain Line Installation

Follow All Local Codes And Ordinances

The drain hose molded end will fit 5/8”, ¾” or 1” diameter connections on the air gap, waste tee or disposer. Cut on the marked line as required for your installation.

If a longer drain hose is required, add up to 42” of length for a total of 10ft. length to the factory installed hose. Use 5/8” or 7/8” inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose clamps.

Secure the drain hose to the air gap, waste tee or disposer with clamps.

NOTE: Total drain hose length must not exceed 10 feet for proper drain operation.

Connect drain line into air gap, waste tee or disposer using either previously determined method.

IMPORTANT: When connecting drain line to disposer, check to be sure that drain plug has been removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE.

9

Page 33
Image 33
Avanti DW184B, DW183W, DW182ESS instruction manual ¾Push Dishwasher Into Final Position, ¾Drain Line Installation