HANDLE REMOVAL (CONT.)

HANDLE REINSTALLATION

f,,, %_
Place the handle on the door by aligning
handle footprints to fit mounting fasteners and
tighten the set screws with a 2.5 mm (3/32")
Allen wrench.
NOTE: if the handle mounting fasteners need
to be tightened or removed use a 1/4" Allen
wrench
Place the handle on the door by aligning
handle footprints to fit mounting fasteners and
tighten the set screws on the bottom of the
handle with a 3.1 mm (1/8") Allen wrench.
NOTE: if the handle mounting fasteners need
to be tightened or removed use a 1/4" Allen
wrench.
10
DOOR AND DRAWER REMOVAL

DOOR REMOVAL

WARNING

Electric Shock H_ard

•Disconnect electrical supply to the refrigerator
before installing. Failure to do so _uld result in
death or serious injury.
,Do not put hands or feet or metal sticks into the air
vents, base grille, or bottom of the refrigerator, You
may be injured or re_ive an electrical shock.
•Be careful when you work with the hinge, base
grille, and stoppeL You may be injured,
Before you begin, remove food and bins from the
doors,
If your entrance door is too narrow for the refrigerator
to pass through, remove the refrigerator door and
move the refrigerator sideways through the doorway,
To remove the left refrigerator door:
Pull the water tube out of the fitting while
pressing the release ring on the fitting
NOTE :When you pull out the tube, fi_t you
have to push the collet by opposite direction
of arrow in the upper picture and pull the tube
out by direction of arrow,