Avanti IM12-IS Care And Maintenance, Operating Instructions, Starting your Ice maker

Operating Instructions

Starting your Ice maker

•Open the top cover and remove the ice basket.

•Remove any dust or objects that may be in the water tank

•Fill the water tank up to the area marked “MAX”:

•Select desired ice cube size by pressing the “ice size” selector (Small or Large).

•The ice-maker will automatically check the water level in the reservoir periodically. The ice maker will detect any shortage of water and will stop the ice-making cycle, the ADD WATER indicator will be lit. Press the POWER button and fill the reservoir with water. Press the ON/OFF button again to restart the ice-making cycle or wait 3 minutes after the ADD WATER indicator goes out as the ice-maker will begin It’s normal operation cycle automatically.

•When the ice cubes are collected and reach the bin sensor, the ice maker will stop operating and the ICE FULL indicator will be lit.

•There are two sizes of ice cubes available, therefore the larger the ice cube selected, the longer the time it will take to complete the cycle. When the ambient temperature is lower than 15°C (59ºF), the small ice cubes sizes are recommended to avoid ice cubes clumping together.

•For best performance, water temperature should be between 7°C (45ºF) and 35°C (95ºF) and ambient between 15°C (59ºF) and 25°C (77ºF).

Getting Ice from the Ice-bin

•Open the top cover to access the ice basket.

•Remove the amount of ice as desired and close the top.

CARE AND MAINTENANCE

Caution

Failure to unplug the ice maker could result in electrical shock or personal injury.

Cleaning Your Ice Maker

•To ensure the cleanliness of the ice cubes, water in the reservoir should be replaced every 24 hours.

•Remove the drain plug to drain remaining water from the water reservoir when the ice maker will not be used for long period of time. Screw the drain plug back in place after the water has been drained.

•Always change with fresh water before starting ice production at initial installation or after long shut-off periods.

•Please clean your Ice maker regularly. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.

Space Requirements

•During transportation, the incline angle of the cabinet should not be over 45°

•Do not turn the Ice maker upside down. Problems could occur in the compressor and sealed system.

•The Ice maker should be placed horizontally on a properly leveled surface.

•To ensure proper ventilation for your Ice maker allow 6” of space at the top, the back and on each side.

•Before using the Ice maker for the first time, please wait 2 hours after positioning it.

•Clean the inner liner, ice-bin, water box, water cup frequently.

IMPORTANT: Do not install the Ice maker near an oven, radiator, or other heat source.

10