IMPORTANT SAFEGUIDES
BEFORE THE APPLIANCE IS USED, IT MUST BE PROPERLY POSITIONED AND INSTALLED AS DESCRIBED IN THIS MANUAL,SO READ THE MANUAL CAREFULLY. TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR INJURY WHEN USING THE APPLIANCE, FOLLOW BASIC PRECAUTION, INCLUDING THE FOLLOWING:
?PLUG INTO A GROUNDED 3- PRONG OUTLET, DO NOT REMOVE GROUNDING PRONG, DO NOT USE AN ADA PTER, AND DO NOT USEAN EXTENSION CORD.
?REPLACE ALL PANELS BEFORE OPERATING.
?IT IS RECOMMENDED THAT A SEPARATE CIRCUIT, SERVING ONLY YOUR APPLIANCE BE PROVIDED. USE RECEPTACLES THAT CANNOT BE TURNED OFF BY A SWITCH OR PULL CHAIN.
?NEVER CLEANAPPLIANCE PARTS WITH FLAMMABLE FLUIDS. THESE FUMES CAN CREATE A FIRE HAZARD OR EXPLOSION. AND DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPO RS AND LIQUIDS IN THE VICINITY OF THIS OR A NY OTHER APPLIANCE. THE FUMES CAN CREATE A FIRE HAZARD OR EXPLOSION.
?BEFORE PROCEEDING WITH CLEANING AND MAINTENANCE OPERATIONS, MAKE SURE THE POWER LINE OF THE UNIT IS DISCONNECTED.
?DO NOT CONNECT OR DISCONNECT THE ELECTRIC PLUG WHEN YOUR HANDS ARE WET .
?UNPLUG THE APPLIANCE OR DISCONNECT POWER BEFORE CLEANING OR SERVICING. FAILURE TO DO SO CAN RESULT IN ELECTRICAL SHOCK OR DEATH.
?DO NOT ATTEMPT TO REPA IR OR REPLACE ANY PART OF YOUR APPLIANCE UNLESS IT IS SPECIFICALLY RECOMMENDED IN THIS MATERIAL. ALL OTHER SERVICI NG SHOULD BE REFERRED TO A QUALIFIED TECHN ICIAN.
?USE TWO OR MORE PEOPLE TO MOVE AND INSTALL APPLIANCE. FAILURE TO DO SO CAN RESULT IN BACK OR OTHER INJURY.
?TO ENSURE PROPER VENTILATION FOR YOUR APPLIANCE, THE FRONT OF THE UNIT MUST BE COMPLETELY UNOBSTRUCTED. CHOOSE A
ABOVE 55? (13? ) AND BELOW 90? (32? ). THIS UNIT MUST BEINSTALLED IN AN AREA PROTECTED FROM THE ELEMENT, SUCH AS WIND, RAIN, WATER SPRAY OR DRIPS.
?THE APPLIANCE SHOULD NOT BE LOCATED NEXT TO OVENS, GRILLS OR OTHER SOURCES OF HIGH HEAT.
?THE APPLIANCE MUST BE INSTALLED WITH ALL ELECTRICAL, WATER AND DRAIN CONNECTIONS IN ACCORDANCE WITH STATE AND LOCAL CODES. A STANDARD ELECTRICAL SUPPLY (115 V AC ONLY, 60 HZ), PROPERLY GROUNDED IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE AND LOCAL CODES AND ORDINANCES IS REQUIRED.
?DO NOT KINK OR PINCH THE POWER SUPPLY CORD OF APPLIANCE.
?THE FUSE (OR CIRCUIT BREAKER) SIZE SHOULD BE 15 AMPERES.
?IT IS IMPORTANT FOR THE APPLIANCE TO BE LEVELED IN ORDER TO WORK PROPERLY. YOU MAY NEED TO MAKE SEVERAL ADJUSTMENTS TO LEVEL IT.
?ALL INSTALLA TION MUST BE IN ACCORDANCE WITH LOCAL PL UMBING CODE REQUIREMENTS.
?MAKE CERTAIN THAT THE PIPES ARE NOT PINCHED OR KINKED OR DAMAGED DURING INSTALLATIONS.
?CHECK FOR LEAKS AFTER CONNECTION.
?NEVER ALLOW CHILDREN TO OPERATE, PLAY WITH OR CRAWL INSIDE THE ICE MA KER.
?IF YOU USE THE DRAINAGE CONTAINER, YOU MUST SET THE DRAIN SELECT SWITCH TO OFF OR THE WATER CAN OVERFLOW FROM THE DRAINAGE CONTAINER
?ALTHOUGH THE UNIT HAS BEEN TESTED AT THE FACTORY, DUE TO LONG- TERM TRANSIT AND STORAGE, THE FIRST BATCH OF CUBES MUST BE DISCARDED.
?DO NOT USE SOLVENT- BASED CLEANING AGENTS OF ABRASIVES ON TH E INTERIOR. THESE CLEANERS MAY DAMAGE OR DISCOLOR THE INTERIOR.
?DO NOT USE THIS APPA RATUS FOR OTHER THAN ITS INTENDED PURPOSE.
3
