IMPORTANT SAFETY INSTRUCTIONS
?WARNING?
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY WHEN USING YOUR APPLIANCE, FOLLOW THESE BASIC PRECAUTIONS:
?READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.
?DANGER OR WARNING: RISK OF CHILD ENTRAPMENT.
CHILD ENTRAPMENT AND SUFFOCATION ARE NOT PROBLEMS OF THE PAST. JUNKED OR ABANDONED APPLIANCES ARE STILL DANGEROUS. . . EVEN IF THEY WILL “JUST SIT IN THE GARAGE A FEW DAYS.”
?BEFORE YOU THROW AWAY YOUR APPLIANCE: TAKE OFF THE DOORS. LEAVE THE SHELVES IN PLACE SO THAT CHILDREN MAY NOT EASILY CLIMB INSIDE.
?NEVER ALLOW CHILDREN TO OPERATE, PLAY WITH, OR CRAWL INSIDE THE APPLIANCE.
?NEVER CLEAN APPLIANCE PARTS WITH FLAMMABLE FLUIDS. THE FUMES CAN CREATE A FIRE HAZARD OR EXPLOSION.
?DO NOT STORE OR USE GASOLINE OR ANY OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. THE FUMES CAN CREATE A FIRE HAZARD OR EXPLOSION.
INSTALLATION INSTRUCTIONS
?BEFORE USING YOUR APPLIANCE
?REMOVE THE EXTERIOR AND INTERIOR PACKING.
?CHECK TO BE SURE YOU HAVE ALL OF THE FOLLOWING PARTS:
?1 ICE BUCKET
?1 WINE BOTTLE SHELF
?1 STRAIGHT SHELF
?1 BOTTOM RACK
?1 PLASTIC SCOOP
?25 FEET HOSE
?1 INSTRUCTION MANUAL
?BEFORE CONNECTING THE APPLIANCE TO THE POWER SOURCE, LET IT STAND UPRIGHT FOR APPROXIMATELY 2 HOURS. THIS WILL REDUCE THE POSSIBILITY OF A MALFUNCTION IN THE COOLING SYSTEM FROMHANDLING DURING TRANSPORTATION.
?CLEAN THE INTERIOR SURFACE WITH LUKEWARMWATER USING A SOFT CLOTH.
?INSTALLATION OF YOUR APPLIANCE
?THIS APPLIANCE IS DESIGNED TO BE RECESSED OR
?PLACE YOUR APPLIANCE ON A FLOOR THAT IS STRONG ENOUGH TO SUPPORT THE APPLIANCE WHEN IT IS FULLY LOADED. REMEMBER THAT THE UNIT WILL BE SIGNIFICANTLY HEAVIER ONCE IT IS FULLY LOADED.TO LEVEL YOUR APPLIANCE, ADJUST THE LEGS AT THE FRONT OF THE APPLIANCE.
?LOCATE THE APPLIANCE AWAY FROM DIRECT SUNLIGHT AND SOURCES OF HEAT (STOVE, HEATER, RADIATOR, ETC.). DIRECT SUNLIGHT MAY AFFECT THE ACRYLIC COATING AND HEAT SOURCES MAY INCREASE ELECTRICAL CONSUMPTION. EXTREME COLD AMBIENT TEMPERATURES MAY ALSO CAUSE THE APPLIANCE NOT TO PERFORM PROPERLY.
?AVOID LOCATING THE APPLIANCE IN MOIST AREAS. TOO MUCH MOISTURE IN THE AIR WILL CAUSE FROST TO FORM QUICKLY ON THE EVAPORATOR REQUIRING MORE FREQUENT DEFROSTING OF THE APPLIANCE.
9
