EAR-NOSE-BROW TRIMMER
Instructions
INSTALLATION/ REMOVAL OF TRIMMING HEADS
Make sure trimmer unit is turned “OFF”. 1 Turn trimmer head counterclockwise 1/4
turn and lift off.
2 Place trimmer head
on trimmer and turn trimmer head clockwise 1/4 turn to lock on.
TRIMMING NOSE HAIR
Make sure the nasal passages are clean. Slowly move the rotary blade/detailer in and out of each nostril, no more than
TRIMMING EAR HAIR
Make sure the outer areas of the ears do not con- tain any wax. Hold the ear flat with one hand and carefully insert rotary blade/detailer no more than
TRIMMING EYEBROWS
Slowly move rotary blade/detailer to neatly trim stray hairs. For precise, even trimming, slowly move the rotary blade/detailer closer or farther away from eyebrows to achieve desired length.
TRIMMING WITH EYEBOW ATTACHMENT COMB
To install eyebrow attachment comb, you must use the recipro- cating head and place eyebrow attachment comb over it. The attachment comb allows you to trim and shape eyebrows. Trim by following in the direction of hair growth.
SIDEBURNS AND MUSTACHE
For detailing sideburns and mustache, use detailing head across desired areas. For trimming sideburns slowly move detailing head across desired area.
TRIMMING PRIVATES
For hard to reach or tight areas, use the detailer head. Slowly move the detailer through area to trim until desired look is accomplished.
TROUBLESHOOTING
If your Trimmer does not seem to take a charge, check the following before returning it for repair:
1.Check outlet current by plugging in another appliance.
2.Make sure the outlet simply is not connected to a light switch which turns the power at the outlet off when lights are turned off.
3.Be sure the trimmer is properly connected to the recharging transformer, all connections are secure and the switch on the trimmer is turned “OFF - 0.”
4.If your electricity is connected to a master power switch, we suggest the trimmer be disconnected from the charger anytime the master switch is off. Leaving the unit plugged into a dead outlet or an unplugged charger will drain the battery.
5.If trimmer does not run and it is completely charged, turn the unit “ON - I” and pinch or push the blades manually. (Oil may have dried out between the blades, so they may be temporarily stuck together.)
For the cleaning and care instructions of your trimmer, please download the Care Instructions.
SERVICE AND REPAIR
If you have problems with your WAHL product, send it prepaid with a note explaining the problem to:
Wahl Clipper Corporation
Attn: Repair Department
3001 Locust Street
Sterling, IL 61081
Telephone (815)
For products purchased outside the United States,
contact your distributor.
