Avanti MO9005BST Before Using Your Microwave Oven, Free Standing / Countertop Installation

INSTALLATION INSTRUCTIONS

BEFORE USING YOUR MICROWAVE OVEN

•Remove the exterior and interior packing.

•Check to be sure you have all of the following parts:

•Glass Tray

•Turntable Roller Assembly (Roller or Roller Ring)

•Built-in Trim Kit

•Instruction Manual

•Inspect the oven after unpacking for any visual damage such as:

•Misaligned Door

•Damaged Door

•Dents or Holes in Door Window and Screen

•Dents in Cavity

If any of the above is visible, DO NOT use the oven.

FREE STANDING / COUNTERTOP INSTALLATION

OF YOUR MICROWAVE OVEN

(For Built-in Installation, see Installation Guide included with the installation kit).

•When positioning the microwave oven, it should be set on a flat, steady surface.

•Do not block air vents. If they are blocked during operation, the oven may overheat and eventually cause oven failure.

•Poor television reception and radio interference may result if the oven is located close to a TV, radio, antenna, or antenna wire. Position the oven as far from them as possible.

•Clean the interior surface with lukewarm water using a soft cloth.

•Keep the oven away from hot air, steam or splashing liquids when choosing a place to locate it, otherwise, the unit’s operation may be adversely affected, causing it to break down.

•Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.

•Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.

•DO NOT place anything on the top of the oven.

•Keep the oven at least 5 inches away from both sidewalls and away from rear wall to ensure the proper ventilation.

•DO NOT remove the turn-table drive shaft.

7