Getting Ice from the Ice-bin
•Pull the ice bin forward and remove.
•Remove the amount of ice as desired and close by inserting the
CARE AND MAINTENANCE
Caution
Failure to unplug the ice maker could result in electrical shock or personal injury.
Cleaning Your Ice Maker
•To ensure the cleanliness of the ice cubes, water in the reservoir should be replaced every 24 hours.
•Remove the drain plug to drain remaining water from the water reservoir when the ice maker will not be used for long period of time. Screw the drain plug back in place after the water has been drained.
•Always change with fresh water before starting ice production at initial installation or after long
•Please clean your Ice maker regularly. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
Space Requirements
•During transportation, the incline angle of the cabinet should not be over 45°
•Do not turn the Ice maker upside down. Problems could occur in the compressor and sealed system.
•The Ice maker should be placed horizontally on a properly leveled surface.
•To ensure proper ventilation for your Ice maker allow 6” of space at the top, the back and on each side.
•Before using the Ice maker for the first time, please wait 2 hours after positioning it.
•Clean the inner liner,
IMPORTANT: Do not install the Ice maker near an oven, radiator, or other heat source.
Power Failure
Most power failures are corrected within a few hours and should not affect the temperature of your ice maker if you minimize the number of times the
11