Maintenance
Change Engine Oil |
|
| Service Air Filter |
|
|
| |||
! | WARNING |
| ! |
| ! | WARNING |
|
| ! |
DO NOT attempt any maintenance, adjustments or service | Never start or run the engine with the air cleaner assembly | ||||||||
with engine and blade running. STOP engine and blade. | (if equipped) or the air filter (if equipped) removed. |
| |||||||
Remove starter insert. Disconnect spark plug wire and |
| NOTE: Do not use pressurized air or solvents to clean the | |||||||
secure away from spark plug. Engine and components |
| ||||||||
are HOT. Avoid serious burns, allow sufficient time for all | filter. Pressurized air can damage the filter and solvents will | ||||||||
components to cool. |
|
|
| dissolve the filter. |
|
|
|
| |
1. Drain the fuel tank completely. |
|
| 1. | Remove the fastener (A, Figure 14) and the air filter | |||||
2. Remove the dipstick (A, Figure 13), then turn the |
|
| cover (B). |
|
|
|
| ||
mower on its side. Allow the oil to drain from the oil fill | 2. | Remove the |
|
| |||||
tube into an appropriate container. Dispose of used oil | 3. | To loosen debris, gently tap the filter on a hard surface. | |||||||
properly. |
|
|
|
| If the filter is excessively dirty, replace with a new filter. | ||||
3. Place the mower upright, then fill the engine with |
| 4. | Wash the | ||||||
engine oil to the ‘full’ mark on the dipstick. Briggs & |
| allow it to thoroughly air dry. Do not oil the | |||||||
Stratton |
| 5. | Assemble the dry |
|
| ||||
recommended. Do not overfill. |
|
| 6. | Install the filter and | |||||
|
|
|
|
| su filter fits securely in the base. |
|
|
| |
A |
|
|
| 7. | Install air filter cover a d secure with fastener. Make | ||||
|
|
|
| su e the fastener | s tight. |
|
|
| |
|
|
|
|
|
|
|
| ||
|
|
|
|
| A |
|
|
|
|
|
|
|
|
|
|
| B |
|
|
|
|
|
|
|
|
| D |
|
|
Figure 13: Draining the engine oil |
|
|
|
|
|
|
|
| |
|
|
|
|
|
| E |
| C |
|
|
| Reproduction |
|
|
| ||||
|
|
|
| Figure 14: Air filter and |
|
|
|
16 | www.snapper.com |