Snapper NXT22875EFCA, 7800696, 7800580 manual Troubleshooting, Probable Cause, Corrective Action

Models: NXT22875EFCA NXT22875E 7800580 7800696

1 72
Download 72 pages 3.92 Kb
Page 19
Image 19
Troubleshooting

 

 

 

 

 

 

 

Troubleshooting

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PROBLEM

 

 

PROBABLE CAUSE

 

CORRECTIVE ACTION

Engine Will Not Start

1.

Fuel tank empty.

 

1.

Fill fuel tank with fresh fuel.

 

 

2.

Starter insert not installed.

 

2.

Install starter insert into control console.

 

 

3.

Spark plug wire disconnected.

3.

Place spark plug wire onto spark plug.

 

 

4.

Wiring harness disconnected.

4.

Connect wiring harness.

 

 

5.

Battery dead.

 

5.

Charge or replace battery.

 

Engine Stalls or Loses

1.

Blade control is released or is not being held

1.

Blade control should be held securely against

 

Power After Running

securely against drive control.

 

drive control at all times during operation.

 

 

 

 

 

 

 

 

 

2.

Fuel tank empty.

 

2.

Fill with fuel to proper level.

 

3.

Engine pre-cleaner and/or air cleaner dirty.

3.

Clean or replace precleaner and/or air cleaner.

 

 

4.

Spark plug fouled or gap set improperly.

4.

Service spark plug.

 

 

5.

Water, debris or stale fuel in fuel system.

5.

Drain and clean fuel system.

 

Excessive Vibration

1.

Damaged, out of balance or bent mower blade.

1.

Contact authorized dealer.

 

 

2.

Loose blade components.

 

2.

Contact authorized dealer.

 

 

3.

Loose or missing air lift (if equipped).

3.

Contact authorized dealer.

 

 

4.

Lumpy or frayed belt.

 

4.

Contact authorized dealer.

 

Mower Will Not Move/

1.

Build-up of debris on or around drive

1.

Clean debris.

 

 

Loss Of Traction

components.

Reproduction

 

 

 

 

 

 

 

 

2.

Transmission cable adjustment requi ed.

2.

Adjust tra smission cable.

 

 

 

 

 

 

 

 

 

3.

Drive belt requires replacement.

3.

Contact auth

rized dealer.

 

4.

Damaged transmission.

 

4.

Contact auth

rized dealer.

 

Cutting Grass Improperly

1.

Cutting height too low or high.

1.

Adjust cutt ng height.

 

 

2.

Forward speed too fast.

 

2.

Adjust o a slower speed.

 

 

3.

Cutting blade dull r damaged.

3.

Conta t authorized dealer.

 

Poor Grass Discharge

1.

Forward speed too fast.

 

1.

Adjust to a slower speed.

 

 

2.

Grass is wet.

 

2.

Mow when grass is dry.

 

 

3.

Excessively worn or damaged bla e.

3.

Contact authorized dealer.

 

 

4.

Build up of grass clippings and debris un er

4.

Clean deck.

 

 

 

deck.

 

 

 

 

 

 

 

5.

Improper blade installed

deck.

5.

Contact authorized dealer.

 

 

6.

Blade installed impro erly on deck.

6.

Contact authorized dealer.

 

Oil Leaking

1.

Loose dipstick.

 

1.

Make sure dipstick/oil filler cap is securely in

 

 

 

 

 

 

place.

 

 

 

2.

Loose drain plug.

 

2.

Check and tighten drain plug.

 

 

3.

Oil level is overfilled.

 

3.

Drain excess oil.

 

 

 

 

 

 

 

 

 

4.

Damaged oil seals.

 

4.

Contact authorized dealer.

 

 

 

 

 

 

 

 

 

19

Page 19
Image 19
Snapper NXT22875EFCA, 7800696, 7800580 manual Troubleshooting, Probable Cause, Corrective Action