Avanti SHP1703PS, SHP1712SDC, SHP1702SS Important Safety Instructions, Installation Instructions

WARNING

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, or injury when using your refrigerator, follow these basic precautions:

•Read all instructions before using the refrigerator.

•DANGER or WARNING: Risk of child entrapment.

Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous . . . even if they will “just sit in the garage a few days”.

•Before you throw away your old refrigerator: Take off the door. Leave the shelf in place so that children may not easily climb inside.

•Never allow children to operate, play with, or crawl inside the refrigerator.

•Never clean refrigerator parts with flammable fluids. The fumes can create a fire hazard or explosion.

•Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other refrigerator. The fumes can create a fire hazard or explosion.

•Do not repair or replace any part of the refrigerator or attempt any servicing unless specifically recommended in the user-maintenance instructions or in published user-repair instructions. Replace the fuse with the same type.

-Save these instructions-

INSTALLATION INSTRUCTIONS

Before Using Your Refrigerator

•Remove the exterior and interior packing.

•Check to be sure you have all of the following parts:

•2 Shelves

•1 Instruction manual

•1 AC Power Cable (Detachable) – Model SHP1712SDC ONLY

•1 DC Power Cable (Detachable) – Model SHP1712SDC ONLY

•Clean the interior surface with lukewarm water using a soft cloth.

Installing Your Refrigerator

•This refrigerator uses superconductor heat-pipe refrigeration technology (no compressor).

•This appliance is designed to be free standing only, and should not be recessed or built-in (Fully recessed).

•Place your refrigerator on a floor that is strong enough to support the refrigerator when it is fully loaded.

•Allow 5 inches of space between the back and sides of the refrigerator, which allows the proper air circulation to cool the heat sink.

•Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the refrigerator not to perform properly.

•Avoid locating the refrigerator in moist areas.

•Plug the refrigerator into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.

•After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing food in the refrigerator compartment.

7