Kramer Electronics 2900-3000730 Rev 2 Installing the TBUS-6xl, Assembling the Inner Frame

5 Installing the TBUS-6xl

To install the TBUS-6xlperform the following steps:

1.Assemble the inner frame (see Section 5.1).

2.Install the inner frame (see Section 5.2).

3.Cut an opening in the table (see Section 5.3).

4.Insert the unit through the opening and secure to the table (see Section 5.4).

5.Connect the cables (see Section 5.5).

6.Insert pass-through cables (see Section 5.6)

7.Adjust the height of the inner frame (see Section 5.7).

5.1Assembling the Inner Frame

The modules mounted on the inner frame can include single inserts and/or dual inserts as well as a power socket (in some models). This section describes how to assemble these modules.

i Each module kit comes with detailed assembly instructions.

5.1.1Mounting the Inserts

You can rearrange or remove any of the plates mounted on the inner frame and replace them with Kramer passive wall plates or connector modules for interfacing A/V type signals.

To mount a Kramer insert or connector module:

1.Unscrew the two screws that fasten the blank plate to the inner frame and remove the blank plate.

2.Place the required Kramer insert over the opening, insert the two screws to fix the Kramer insert in place, and tighten them.

8 TBUS-6xl - Installing the TBUS-6xl