Kramer Electronics 2900-3000730 Rev 2 Inserting the TBUS-6xl through the Cut Out Opening

5.4Inserting the TBUS-6xl through the Cut Out Opening

To install TBUS-6xlin the opening:

1.Remove the protective rubber guard from around the outer rim of the TBUS-6xlhousing. Beware of the sharp edge!

2.Carefully insert the unit into the prepared opening (see Figure 5).

3.Take the support brackets under the table and place them into the support bracket grooves on both sides of the unit (see Figure 1).

4.Verify proper alignment of the unit before tightening the mounting screws.

5.Tighten both mounting butterfly screws upward until they reach the table surface (from underneath). Tighten firmly (see Figure 5).

6.Tighten the locking butterfly screws downward until tight against the mounting bracket.

Figure 5: Inserting TBUS-6xl into the Prepared Opening

12 TBUS-6xl - Installing the TBUS-6xl