INSTALLATION INSTRUCTIONS
Before Using Your Appliance
•Remove the exterior and interior packing.
•Check to be sure you have all of the following parts:
•1 Bake/Broil/Drip Pan
•1 Oven Rack
•1 Crumb Tray
•1 Tray Handle
•1 Instruction Manual
•Remove all the items inside your oven and clean the interior surface with lukewarm water using a soft cloth.
•Do not attempt to repair or replace any part of your oven unless it is specially recommended in this manual.
•This appliance requires 1500W and should be the only appliance operating on the circuit.
NOTICE
BEFORE YOU USE THIS OVEN FOR THE FIRST TIME: THE HEATING ELEMENTS HAVE A
PROTECTIVE COATING, WHICH MUST BE BURNED OFF BEFORE USE. TO DO THIS, OPEN THE OVEN DOOR AND SET THE TEMPERATURE TO 250°C / 480°F. LEAVE THE APPLIANCE SWITCHED ON FOR APPROXIMATELY 15 MINUTES. IT IS IMPORTANT TO ENSURE ADEQUATE VENTILATION DURING PERIOD AS A BURNING SMELL IS NORMAL DURING THIS PROCESS.
Installation of Your Appliance
Select a location for the appliance. The location should be in an open area on a flat counter where the plug will reach an outlet.
•When positioning the appliance, it should be set on a flat, steady surface.
•Do not block air vents. If they are blocked during operation, the oven may overheat and eventually cause the appliance failure.
•Keep the appliance away from hot air, steam or splashing liquids when choosing a place to locate it, otherwise, the unit’s operation may be adversely affected, causing it to break down.
•Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
•Plug the appliance into an exclusive properly installed grounded wall outlet. Any questions concerning power should be directed toward a certified electrician or an authorized Avanti Products service center.
•Do not place anything on the top of the broiler oven and automatic toaster.
•Keep the appliance at least 5 inches away from rear wall to ensure the proper ventilation.
Electrical Connection
•The appliance has a polarized plug (One blade is wider than the other), to reduce the risk of electric shock, this plug is intended to fit into the polarized outlet only one way. If the plug does not fit fully into the outlet, reserve the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.
•A short power cord is provided to reduce the hazards resulting from entanglement or tripping over a longer cord. An extension cord may be used with care, however, be sure the marked electrical rating is at least as great as the rating of this appliance. The extension cord should be positioned such that it does not drape over the counter or tabletop where it can be pulled on by children or tripped over.
The electrical rating of this appliance is listed on the bottom panel of the appliance.
7
