INSTALLATION INSTRUCTIONS
BEFORE USING YOUR PORTABLE WASHER
∙Remove the exterior and interior packing.
∙You will need the following tools:
∙Wrench
∙Pliers
∙Screwdriver
∙Check to be sure you have all of the following parts:
∙2 Inlet Hoses
∙1 Faucet Adapter
∙1 Noise Proof Plate With Screws
∙1 Drain Hose Assembly
∙1 Water Inlet Plug
SCREWDRIVER | |
WRENCH | PLIERS |
∙Remove shipping brace. Note - It should be saved and used (to prevent damage to washer components) whenever washer is moved or transported to a new location.
∙Clean the interior surface with lukewarm water using a soft cloth.
∙Allow 2 inches of space between the back and sides of the appliance.
∙Put your laundry into the washer evenly. Uneven laundry may cause noise or vibration.
∙DO NOT use excessively hot water (122ºF / 50°C or more). Plastic parts may be deformed or damaged. Also, clothing may be deformed or bleached.
∙Before washing, check all pockets. If nails or pins remain in pockets, they may damage the washer or clothes.
∙Never splash water on the control panel.
∙Plug the washer into an exclusive properly
SELECTING A LOCATION
Before you install the portable washer, select a location with the following characteristics:
∙A hard level surface (if the surface is uneven, see Adjusting The Adjustable Foot section on the next page).
∙Away from direct sunlight. Direct sunlight may affect the acrylic coating, plastic and electrical components.
∙Adequate ventilation.
∙Away from sources of heat such as coal or gas. Make sure that the washing machine does not stand on its power cord.
∙Ventilation openings must not be obstructed by carpeting when the portable washer is installed on a carpeted floor. It is recommended that you place your portable washer on a hard material floor such as tile, concrete, linoleum and to avoid if at all possible placement on wooden floors or carpeted areas.
9
