?PREPARATION
1. | Connect the water inlet hose | 3. | Insert the plug into the | 4. | Place the drain hose in the | ||||
| to the water faucet. Don’t |
| socket. For safety the plug |
| correct position. | ||||
| switch on the power if the |
| should have ground |
|
| ||||
| water pressure is lower than |
| connection. | 5. | Open the door and put the | ||||
| 0.05MPa and higher than |
|
|
| wash load into the tub | ||||
| 0.5MPa. |
|
|
| evenly. Then close the door. | ||||
2. | Open the water faucet. |
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
6. Pull out the detergent drawer and add the wash detergent and | 7. Push back the detergent | ||
softener to the corresponding position as following: | drawer. | ||
? | For | WARNING: DO NOT pull out the | |
? | For wash detergent | ||
detergent drawer while the | |||
? | For softener | ||
appliance is in operation because | |||
When using the liquid detergent (recommended for programs | this may cause water to spill out. | ||
without |
| ||
the instructions on the package. |
| ||
When using the soap powder, remember to remove the liquid detergent cup.
NOTE: DO NOT overflow the deterg ent and softener compartment.
?Warning?
When using liquid chlorine bleach you must follow these steps.
Failure to follow these directions may result in damaged clothes.
1.Insert the load to be washed into the unit
2.Turn on the unit to your desired mode.
3.Add dete rgent or liquid soap (see page 12 for details).
4.Wait for 3 minutes after the washing cycle starts. Then measure the correct amount of liquid chlorine bleach (do not exceed 1/3 cup) otherwise you will damage the clothes.
5.Open the drawer and pour the liquid chlorine bleach into center section 2 of drawer
12
