?After plugging the appliance into a wall outlet, allow the unit to cool down for
?Electrical Connection
?Warning?
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized Avanti Products service center.
This unit should be properly grounded for your safety. The po wer cord of this unit is equipped with a
Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For personal safety, this appliance must be properly grounded.
This unit requires a standard 115/120 Volt AC ~/60Hz electrical outlet with
The cord should be secured behind the unit and not left exposed or dangling to prevent accidental injury.
The unit should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating label on the appliance. This provides the best performance and also prevent overloading house wiring circuits that could cause a fire hazard from overheated. Never unplug the unit by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle. Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end. When moving the unit, be careful not to damage the power cord.
?Extension Cord
Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this unit. However, if you must use an extension cord it is absolutely necessary that it be a
?Reversing the Door Swing of Your Wine/Beverage Cooler
This
OPERATING YOUR WINE/BEVERAGE COOLER
?Setting the Temperature Control
? You can set the temperature as you desire by pushing the button UP ( ) or DOWN ( ) when you push the two buttons for the first time, the LED readout will show the original temperature set at previous time (the temperature preset at the factory is 50ºF).
?The temperature that you desire to set will increase 1ºF or 1ºC if you push the UP ( ) once,
the temperature will decrease 1ºF or 1ºC if you push the DOWN ( | ) once. |
10