Avanti WCR4600S Care And Maintenance, ¬ Cleaning Your Wine Chiller, ¬ Power Failure

Models: WCR4600S

1 24
Download 24 pages 16.9 Kb
Page 12
Image 12
CARE AND MAINTENANCE

CARE AND MAINTENANCE

¬CLEANING YOUR WINE CHILLER

Turn off the power, unplug the appliance, and remove all items including shelves.

Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water.

Wash the shelves with a mild detergent solution.

Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.

Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth.

Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless steel with steel particles and rusting may occur.

¬POWER FAILURE

Most power failures are corrected within a few hours and should not affect the temperature of your appliance if you minimize the number of times the door is opened. If the power is going to be off for a longer period of time, you need to take the proper steps to protect your contents.

¬MOVING YOUR WINE CHILLER

Remove all items.

Securely tape down all loose items (shelves) inside your appliance.

Tape the door shut.

Be sure the appliance stays secure in the upright position during transportation. Also protect outside of appliance with a blanket, or similar item.

¬ENERGY SAVING TIPS

The Wine Chiller should be located in the coolest area of the room, away from heat producing appliances, and out of the direct sunlight.

CHARCOAL FILTRATION SYSTEM

Your wine is a living object that breathes through the cork of its bottle. In order to preserve the quality and taste of your fine wines, they must be stored at the ideal temperature and ambient conditions. Your cellar is equipped with an active charcoal filtration system to ensure air purity, cooling efficiency, and to maintain an odor free cabinet for the storage of your fine wines. The filter assembly is located at the rear panel inside your cellar.

Keep in mind, that this filter must be changed every 12 months.

To purchase replacement filters, call our Parts / Service Department at 1 – 800 – 220 – 5570. To replace your filter:

1

Remove the bottles of wine stored on the two (2)

 

 

shelves in front of the filter.

 

2

Remove the shelves and set aside to be replaced

 

 

once you have changed the filter

 

3

Hold the filter and turn it at 45 degrees in the

 

 

counter-clockwise direction and then pull it out.

 

4

Remove the existing filter and replace with a new

 

 

one.

 

5

Put the new filter into the hole and then turn the filter

 

 

at 45 degrees in clockwise direction.

 

 

 

Figure / Image for reference only.

 

 

 

 

12

 

Page 12
Image 12
Avanti WCR4600S Care And Maintenance, ¬ Cleaning Your Wine Chiller, ¬ Power Failure, ¬ Moving Your Wine Chiller