INSTALLATION INSTRUCTIONS
¬BEFORE USING YOUR WINE CHILLER
•Remove the exterior and interior packing.
•Check to be sure you have all of the following parts:
1 Instruction Manual
5 Large Shelves
1 Display Shelf
2 Keys
•Before connecting this appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
•Clean the interior surface with lukewarm water using a soft cloth.
¬INSTALLATION OF YOUR WINE CHILLER
•This appliance is designed to be for free standing installation or
•Place your Wine Chiller on a floor that is strong enough to support it when it is fully loaded. To level your Wine Chiller, adjust the front leveling legs at the bottom of the Wine Chiller.
•Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.
•Avoid locating the unit in moist areas.
•Plug the Wine Chiller into an exclusive, properly
¬BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both
← Figure shown
Cabinet Opening Dimensions
IN (min) MM (min)
Width 24” 610 mm
Depth 26” 661 mm
Height 35” 889 mm
|
|
| Figure shown → | |
| Unit Dimensions |
|
| |
|
| IN (min) |
| MM (min) |
Width |
| 23 1/2” |
| 597 mm |
Depth |
| 24 ½” |
| 623 mm |
(with handle) |
|
|
|
|
Depth |
| 22 3/4” |
| 578 mm |
(without Handle) |
|
|
| |
Height |
| 34 ¼” |
| 889 mm |
|
|
| 8 |