2
PROCEDURES FOR USING THE FEATURES
To answer or place a call
Note:The Message light flashes when a call is coming in
(that is, when the telephone is ringing).
1To place or answer a call, lift the handset.
2To place a call, next, dial the desired number.
3To end the call, hang up the handset.
Note:To raise the volume of the handset, press the upper
half of the Handset volume control button labeled ; to
lower the volume of the handset, press the lower half o f the
Handset volume control button labeled .
To put a call on hold
1Press . (The red light next to goes on.)
To return to the held call
1Press , or, if you have hung up the handset,
lift the handset again from the cradle.
(The red light next to goes off.)
•You are reconnected to the other party.
ANSWERING AND PLACING A CALL
HOLD
To retrieve a message when your Message light is
blinking
1See your system manager for instructions about you r
local message retrieval procedures.
Note:The Message light also flashes when a call is co ming
in (that is, when the telephone is ringing).
To redial the last number that you dialed
1While off-hook, press .
(The telephone will redial up to 32 digits.)
To control the volume of the tone ringer
Note:The volume control is labeled .
1To raise the volume of the ringer, slide the Ringer volume
control upwards; to lower the volume of the ringer, slide
the Ringer volume control downwards.
M
ESSAGE
REDIAL
RINGER VOLUME
Figure 2. The Bottom of the 6200 Series Telephones
2Remove the desk stand by sliding it to the left unt il it is
free of the telephone base.
PROCEDURES FOR INSTALLING THE
TELEPHONE
TABLE/DESK INSTALLATION
Use the 7-foot straight line cord that came with y our
telephone to connect the telephone to a modular jack.
!WARNING:
Do not plug the handset cord into the line jack or th e
data jack on your telephone since it could damage your
handset and the telephone.
1Turn the telephone upside down so that you can see the
bottom of the telephone. See Figure 2.
Desktop
Line jack
stand
wall mounting
4 holes for
Figure 3. Sliding the Base from the Bottom of the Set
3Plug one end of the line cord into the line jack on th e
bottom of the telephone.
4Align the other end of the line cord so that it appea rs
through the slot at the top of the stand and reattach the
stand to the telephone by sliding the stand into the
appropriate tabs and then to the right.
5After you have attached the stand to the telepho ne, use
the screw provided to tighten the stand onto the bac k of
the telephone set.
Slide stand
to left and lift
Desktop
stand
Figure 4. Tightening the Stand to Back of the Telephone
6Turn the telephone right-side up and place it on your desk
or table.
7Plug one end of the coiled handset cord into the ha ndset
jack on the side of the telephone.
8Plug the other end of the handset cord into the hand set.
9Hang up the handset.
10 Plug the free end of the line cord into a modular wall j ack.
11 Lift the handset and listen for dial tone.
12 Set the Ringer Volume Control switch to the setting you
want.
WALL INSTALLATION
Use the following directions to mount the telephone on a
standard wallphone jack with mounting studs.
Note:For wall installation, do NOT unbundle the line cor d
packaged with the telephone; that is, leave the line cord in its
coiled position.
1You must reverse the handset tab (which holds the
handset when you hang up). See Figure 4.
•Hold down the switchhook and slide the handset tab up
and out of its slot.
•Turn the tab so that the curved end is facing up.
•Insert the tab back into its slot.
a. Handset b. Press to release
retainer
in place
and then remove
handset retainer