Installation Procedures for Dual Radio Modules Installing the MDW 9040 Pocket Phone System
MDW Wireless Pocket Phone Installation and Use,
503-801-190 Issue 2,February 2001 15
3 Place the mounting plate against the wall, and align the screw holes on the plate
with the holes that you have marked on the wall. Start the screws, and screw them
in until the plate rests flush against the wall.
4 Place the keyhole-shaped openings on the back of the radio module over the
screw heads, then slide the radio module downward until it locks into place.
5 Follow the installation procedures for “Installing a Dual Radio Module,”
“Installing Multiple Radio Modules for Single Zone Operation,” or “Installing
Multiple Radio Modules in a Dual Zone Configuration.”
Installing a Dual Radio Module
To install one radio module on a desk or shelf:
1 Remove the radio module from its shipping box and place it in the location you
have selected (for wall-mounting instructions, see “Wall-Mounting the Dual
Radio Module” on page 14).
2 For the first handset to be connected to the radio module, connect a 14 foot
(4.2 m) Station Line Cord (provided) to Line 1 on the radio module and then
connect the other end of the cord to a station port at the main communication
system. If a second handset is to be connected to the radio module, connect
another Station Line Cord to Line 2 on the radio module and then connect the
other end of that cord to another station port.
Note: If the radio module cannot be connected to an associated switch, it can be
temporarily connected to an auxiliary power supply that can provide
electrical power.
3 Verify that the radio module has power and that the status LED information is
correct. See “Dual Radio Module Light Indications” on page 10.
4 Proceed to “Setting Up and Registering the Handset” on page 35.
Installing Multiple Radio Modules for Single Zone Operation
Two or more radio modules must be connected so that their transmission and reception signals will be
synchronized. In this way, the signals transmitted to or received by one radio module will not interfere with
another. This synchronization can be done in a single zone (see below) or a dual zone configuration (see
page 17).
Screw
Holes
Wall-mounting Plate