Avaya MDW 9040 - page 45

Setting Up and Registering the Handset Registering the Pocket Phone to a Dual Radio Module
MDW 9040 Wireless Pocket Phone Installation and Use, 503-801-190 Issue 2,February 2001 37
The LEDs on the radio module have the following meaning.
7 To exit any screen and move back to the previous screen, OR, if you do not want
to make any changes at this time, press the Softkey ( ) below Back.
8 Proceed to the instructions in “Mapping to the Correct Communications System”
on page 40.
Registering the Second Zone of a Dual Zone Configuration
To register your handset with the radio modules to which it will be connected in a
dual zone configuration:
1 Follow the procedures in the previous section, “Registering a Handset” on
page 35.
2 Select Zone 2 in Step 5 to register the handset with the other radio module with
which it will be associated for dual zone operation.
The following occurs:
•The second radio module makes checks regarding the handset registration
request.
•If there are no unexpected conditions, the associated base module and
handset communicate using special link-up signaling.
•The handset displays a “Registration Completed” message to the user.
The LEDs on the radio module have the following meaning.
Flashing Power LED Handset is in Registration Mode
for Line 1
Flashing Control LED Handset is in Registration Mode
for Line 2
IMPORTANT NOTE: The radio module will NOT allow the registration
process to occur if there is anything preventing registration such as the radio
module actively communicating with a previously registered handset.
Flashing Power LED Handset is in Registration Mode
for Line 1
Flashing Control LED Handset is in Registration Mode
for Line 2
IMPORTANT NOTE: The radio module will NOT allow the registration
process to occur if there is anything preventing registration such as the radio
module actively communicating with a previously registered handset.